Inspect a Forklift
Workplace injuries related to forklift operation within North America average about over 10,000 every year, according to the statistics from the HRSDC and OSHA. Some injuries result from the lack of maintenance of the machinery and proper equipment inspection. Other injuries are caused by operator error.
Injuries are not the only problems which are related to the operation and maintenance of forklifts. Another serious issue is damage to property. Lift truck accidents could cause damage to overhead pipes, sprinklers, and other machines as well as building walls. By completing thorough inspections every day, you could help reduce forklift injuries.
When starting an inspection, turn the engine off. Check the levels of the fuel, engine oil, brake fluid, hydraulic oil and coolant. Visually check the machine's tires looking for signs of wear, correct air pressure and general condition. Visually inspect the forks on the front of the equipment as well. Confirm the condition of the top-clip retaining pin and heel. Check that the backrest is attached securely. Make certain that both the overhead and finger guards are attached. Visually inspect the stops and cables, the hydraulic hoses and the mast chains too.
You should check the propane tank if you are utilizing liquid propane of LP forklifts. Check for any indications of damage, rust or corrosion. Be sure that the battery has enough levels of electrolyte and which is adequately charged. Visually inspect all belts. Check to confirm the location of the owner's instruction manual and make certain it is located in the designated on-board storage compartment. Confirm the hood latch and make sure that it is functioning as it is supposed to. Inspect the seatbelt and make sure it securely latches and is functioning correctly.
You could turn the engine on after you have done all the steps mentioned above. Carefully listen to the engine. Investigate any unusual sounds immediately. Check that both the parking brake and the service brake are functioning correctly. Confirm that the steering controls and the accelerator are operating at optimum performance levels.